KEPSPEED Inverted Forks

■Custom front fork set with inverted 45mm diameter
・45 outer (already assembled), upper and lower stem bearings and races for Daks Chaly frame (already assembled/please note for some frames, see "Installation" below) Original handlebar lock plate (already assembled)
・Special Φ33 inner tube for exclusive use (already assembled)
・L=255mm axle shaft (already assembled)
・Special meter gear (for 10 inches) (already assembled)
・Disc hub for Monkey (already assembled)
・Dedicated disc rotor offset spacer (already installed)
・Adjustment collar (already assembled)

■Specific brake master cylinders and single-press 2POD brake calipers
■Dedicated Φ187 wave disc rotor
■74cm square-to-rectangular meter cable
■Fork length: 605mm (from top of stem top bracket to center of axle shaft) (Stock: 600mm)
■Fork pitch: 198mm (core-to-core) (stock value +30mm)
■Outer color: Black anodized aluminum / Silver anodized aluminum
■With hydraulic disc brakes
■Country of origin: China
■Manufacturer: KEPSPEED

*[Notes on purchase]
*All GM-MOTO products are custom parts.Since these products are set up in response to the requests of heavy users, there may be parts of the product that change or decrease from the original driving performance.Please use as dress-up parts for show model machines.Therefore, it is not suitable for driving on public roads or tracks.In some cases, it may not be possible to mount the unit on a motorcycle, or adjustments and modifications may be required in various areas.
*If the original handle lock plate is used, modification to the frame is required.Stock handle locks cannot be used.
*Please note that there may be slight specification changes in each part.In such a case, the actual item will be given priority, although it may differ from the image shown in the introduction.
*When installing on Dax, please remove the handle stopper.In the case of Dax, it is not available for all years.Depending on the model year, the stem may not be long enough for installation.Please check the product specifications before installation.
*The stem length of this product is 230mm, the distance from the top of the under bracket to the bottom of the top bracket is 200mm when the included top nut is fully tightened, and the diameter is Φ23.Please measure the stock stem and frame to confirm
*Please have assembly work done in a specialist shop regarding motorcycle maintenance.
*Although these will be stock replacement parts, please make adjustments as necessary.
*We have not verified compatibility with other companies' products.
*Blinker brackets and headlight brackets are not included.
*As for the wheels, since the hubs for monkeys are used, spokes for monkeys are required.Also, centering is required.Adjustment parts other than the supplied parts are required, but please prepare them separately according to the wheel you use.
※There may be some minor specification changes for each product.The actual product takes precedence over the images shown here, which may differ slightly from the images shown here.
※After the start of riding, pay attention to the occurrence of so-called initial loosening and perform frequent inspections to prevent unexpected problems.
※Some minor scratches and scuffs may occur due to transportation issues.

※GM-MOTO does not accept returns for any reason after the product has been installed.In addition, problems after the start of driving are often caused by driving conditions, maintenance conditions, or a mismatch with the condition of the vehicle, and are difficult to distinguish from the causes of individual products. GM-MOTO is not responsible for any problems.
*Because it is made overseas, the molding, welding, painting, etc. may be insufficient.There may be some minor scratches and scuffs due to transportation problems.
*The image may contain other colors.
*There may be changes in product specifications due to the manufacturer's reasons..