Looks like you access from European region.
Would you shop at webike.eu.com?
39.76 USD (6,338 JPY)
Webike Point: +190 pt
(1.19 USD)
Delivery Information
This product is produced on order.
Usually takes around 3-4 weeks to ship.
Product detail
Length: 10cm
Width: 15cm
2 Velcro straps for fastening
For upright forks
Material: neoprene
**The bikes listed in the compatibility list are for reference only.In many cases, the front end may have been modified, and the gap between the fork guards can be narrower than expected, which may make installation more difficult. Please carefully inspect your bike before purchasing.
*Product Handling*
After riding, be sure to remove the Shock Sox.
Then, clean the neoprene properly according to the following procedure.
1. Use cold water: Heat sensitive neoprene is best washed in cold or lukewarm water.
2. Use a mild detergent: Avoid strong detergents and bleach, and use a mild detergent or cleaner specifically designed for neoprene.
3. Hand-wash: Wash gently by hand, not by machine, to avoid damaging the material.
4. Use a soft brush: If there is stuck on dirt, use a soft brush and scrub gently.
5. Rinse well until all detergent is thoroughly rinsed away.
6. It is important to dry it in the shade in a well-ventilated place out of direct sunlight.
Failure to follow the above mentioned instructions may cause the fork tube to be scratched by adhered dirt, which may seriously affect the performance of the product.
Proper cleaning and care will extend the life of your Shock Sox and keep them in top condition.
*The image may contain other products.
*There may be changes in product specifications due to the manufacturer's reasons.
.
SHOCKSOX 10 cm for inverted forks (dirt & street bikes)
Ideal for 50cc-65cc minibikes, E-bikes, Monkey, Gorilla, Dax, Chaly, and APE equipped with upright forks.
It uses multi-Velcro straps for installation and can be easily attached/detached by simply wrapping around the fork.
Shock Sox, "the fork seal protector that can be removed in 10 seconds", is an original wraparound multi-velcro strap fork seal protector for motocross, off-road and street bikes.
Since its release in 2001, it has been the preferred choice of professional and amateur dirt bike and street bike riders worldwide.
Made in the USA.
With Shock Sox, you can enjoy stress-free riding while protecting your bike's fork seals.
Introduction to Shock Sox from Mr. Shand Garcia
6-inch SHOCK SOX - Upside Down Forks for 85cc - 450cc Motocross & Off-Road Dirt Bikes - SHOCK SOX is a wrap-around, neoprene sleeve that covers the lower part of the upper fork tube and the upper part of the lower fork tube, which provides a protective barrier around the fork seals.
The lower part pushes away dirt and debris, and the upper part has an elastic circumferential strap to prevent the SHOCK SOX from moving.
It's like a "helmet" for your fork seals.
Just like your helmet, you put the SHOCK SOX on when riding, and take them off when done!
Installation and removal can be done in 10 seconds.
The wrap-around design makes them easy to put on and take off, enabling you to remove the SHOCK SOX to wash them and the bike.
Competing products are difficult to put on and almost impossible to take off at all, allowing dirt to accumulate under the sleeve.
The original and still #1 - SHOCK SOX, “The 10-Second Removable Fork Seal Protector”, hassle-free fork seal protection for street, off-road, and motocross bikes.
SHOCK SOX, “The 10-Second Removable Fork Seal Protector”, is a product of BERM MOTORSPORTS.
Founded in 2001 and manufactured in the USA, Shock Sox is the only wrap-around multi-velcro strap fork seal protector for the motocross, off-road and street bike markets.
Dirt bike and street bike riders, both professional and amateur, around the world rely on Shock Sox's hassle-free fork seal protectors to eliminate broken fork seals and unnecessary visits to the service and maintenance department.
Mr. Shand Garcia, representative of Shock Sox/Berm Motorsports
Shand Garcia has left his mark on the Texas motocross scene.
The former publisher of Holeshot Magazine (a Texas motocross racing magazine) and current owner of TEXAS BERM (a Texas motocross racing news site) has worked as an announcer for MX race tracks and fostered the racing community through his live broadcasting of MX racing.
He has written his own book on the history of motocross in Texas and has produced a documentary film.
He also supports the motocross community through companies such as Shock Sox and BERM LORDS Graphics.
His passion has a great impact on the future of motocross.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
New arrivals in used
New arrivals in used
Customer Reviews
There are no Customer Review yet.
Full Custom Build Inspiration
