Yamaha OEM Oil SEAL Replacement Effort
I'm going to install this new OEM OIL SEAL ON MY 1987 TW200.This OEM oil seal is located under the clucth lifter arm on the left side of the crankcase. First I had to drain the oil first then remove the left side cover (stator side) from the engine .Need to remove the clutch cable from the clutch lifter arm side..pull back the rubber clutch cable cover and loosen the clutch cable adjuster nuts with 12mm wrench.After removing the clutch cable from the clutch lifter arm ,loosen the clutch lifter arm stopper screw with #2 phillips screwdriver.remove the clutch lifter arm stopper screw and washer.remove the clutch lifter arm.Now I can Clearly see the older oil seal.before removing the older oil seal first I have to remove the snap ring with snap ring pliers.remove the older oil seal with a flat screwdriver.drive in the new seal with a suitable driver or socket that has the seam outside diameter as the seal.Install the snap ring into its groove with snap ring pliers. lubricate the clutch lifter arm upper portion with lithium soap based grease and lower portion of the clutch lifter arm apply fresh engine oil.Insert the lifter arm into the crankcase.Fit the spring into place on the lifter arm.Install the stopper screw with a washer so that it fits into the top groove of the lifter arm shaft.Tighten the stopper screw to 12NM/8.7 FT-LB.PUT BACK the left side cover and the clutch cable.don't forget to add fresh engine oil ,You 're Done.I do lot of stuff my self when its come to repair.DIY or Pay Someone smarter.As usual package arrived on time and neatly packed .WEBIEK High Quality Packaging right there. I have been purchasing lot of parts from the webike store a very long time. never had a problem. Webike Shop Provide Great Coustomer service That's TOP Notch.Great Communication and Smooth Transaction. WEBIKE SHOP way Beyond 5star.Thank You So Much!!! Happy Coustomer Right Here.
View Detail
